Model: AWB Aluminium Dock Plate
AWB dock plates are suitable for handling light loads when the loading dock is lower than the vehicle being loaded.
Load capacity: 600 or 1,200 kg

Models: HFB 55 and HFB 60 Aluminium Dock Plates
HFB 55 and HFB 60 dock plates are suitable for handling light and medium-heavy loads. They are designed for small height differences only.
Load capacity: 1,200 or 4,000 kg

Model: HFB Aluminium Dock Plates
HFB dock plates are suitable for greater height differences than the HFB 55 and HFB 60 models. A transport wheel assembly is also available.
Load capacity: 4,000 kg

Model: HF Aluminium Loading Bridges
HF loading bridges are suitable for large height differences when the vehicle being loaded is higher than the loading dock.
Load capacity: 4,000 kg

Model: BB Auxiliary Dock Bridges
BB dock bridges are installed on a mounting rail at the edge of the loading dock. They are suitable for small height differences ranging from -100 to +30 mm.
Load capacity: 4,000 kg

Model: KBS Aluminium Loading Bridges
KBS loading bridges are installed on a hot-dip galvanised mounting rail at the edge of the loading dock. They are suitable for small height differences ranging from -135 to +90 mm.
Equipped with a lifting handle and locking latch.
Load capacity: 4,000 kg

Model: SKB Aluminium Loading Bridges
SKB loading bridges can be installed permanently or with a lateral sliding mechanism at the edge of the loading dock.
They are suitable for greater height differences ranging from -215 to +175 mm. The spring-assisted mechanism makes them easy and safe to operate.
Load capacity: 1,750–4,000 kg

Model: FBS Steel Loading Bridges
FBS is the most commonly used steel loading bridge. It is suitable for height differences ranging from -250 to +205 mm.
Also available with a hot-dip galvanised finish.
Load capacity: 5,000 or 6,000 kg

Model: FBA Aluminium Loading Bridges
FBA is a spring-assisted loading bridge that can be installed permanently or with a lateral sliding mechanism.
It can accommodate even large height differences between the loading dock and the vehicle being loaded, ranging from -310 to +265 mm.
Load capacity: 4,500 kg

Model: Segmented Loading Lip
Segmented loading lips are available for FBA, FBS and SKB loading bridges.
The segmented lip ensures that the bridge rests evenly on the vehicle being loaded, preventing the load from being supported by only one edge.

Model: FBT Aluminium Loading Bridge
The FBT loading bridge is suitable for low loading docks. Its length provides safe access to the vehicle being loaded, even from a low dock.
Maximum upward height difference: +460 mm
Load capacity: 4,000 kg

Model: Mounting Plate Kit
A mounting plate kit is available when the edge of the loading dock does not have a sufficiently strong steel beam for attaching a loading bridge.

Model: Height-Raising Wedges
Height-raising wedges are designed to increase the loading height of low vehicles and trailers, particularly those with small wheels.
Load capacity: 12,000 kg per pair

Model: SBK Aluminium Threshold Bridge
These aluminium bridges are designed for crossing small thresholds. The height difference H must always be specified when ordering. The bridges can also be manufactured according to the customer's individual dimensions.
Maximum load capacity: 3,000 kg

Model: Protective Pit Covers
Aluminium protective covers for vehicle maintenance pits. The covers are always dimensioned according to the customer's requirements. Three different mounting options are available.
Load capacity: 4,000 kg

Model: MBD Aluminium Loading Bridge
This three-section mobile loading bridge is designed for handling loading heights that are considerably higher than the loading dock surface.
Forklift pockets on the sides of the bridge make it easier to move, for example with a pallet truck.